Contact Us

Tel: +86-757-86685210

Fax: +86-757-86685210

Mob: +86-18802068132

E-mail: info@jensysenergy.com

Add: Floor 2, Bldg. A, Tangtou Tech Ind. Zone, Shishan Town, Nanhai Dist., Foshan, Guangdong,China

Home > Knowledge > Content
Analysis of the advantages and disadvantages of solar panel types Jan 28, 2019

Solar panels can be divided into crystalline silicon panels, polycrystalline silicon panels, and amorphous silicon panels. From the appearance of the above, the four corners of the single crystal silicon cell are arc-shaped, the surface has no pattern; and the four corners of the polycrystalline silicon battery have a square angle, the surface has a pattern similar to ice; and the amorphous silicon battery is our usual The thin film component, unlike the crystalline silicon cell, can be seen as a grid line, and the surface is as clear and smooth as a mirror.

 solar panels

First: use the difference above

For the user, the single crystal silicon battery and the polycrystalline silicon battery are not much different, and their life and stability are good. Although the average conversion efficiency of single crystal silicon cells is about 1% higher than that of polysilicon, since monocrystalline silicon cells can only be made into quasi-squares (four sides are arc-shaped), when forming solar panels, there will be a part of the area. Filling is not full; and polysilicon is square, so there is no such problem, their advantages and disadvantages are as follows:

Crystal silicon components: The power of a single block is relatively high. Under the same footprint, the installed capacity is higher than the film assembly. However, the components are thick and brittle, the high temperature performance is poor, the low light performance is poor, and the annual attenuation rate is high.

Thin film components: The power of a single block is relatively low. However, the power generation performance is high, the high temperature performance is good, the low light performance is good, the shadow blocking power loss is small, and the annual attenuation rate is low. The application environment is wide, beautiful and environmentally friendly.

 

Second: manufacturing process

The energy consumed in the manufacturing process of polycrystalline silicon solar cells is about 30% less than that of mono silicon solar cells. Therefore, polycrystalline silicon solar cells account for a large share of the total global solar cell production, and the manufacturing cost is also lower than that of monocrystalline silicon cells. Therefore, the use of polycrystalline silicon solar cells will be more energy efficient and environmentally friendly!

In fact, there are many semiconductor materials available for manufacturing solar cells. With the development of the materials industry, the variety of solar cells will increase. At present, research and trial production of solar cells, in addition to the silicon series, there are many types of solar cells such as cadmium sulfide, gallium arsenide, copper indium selenium, etc., these materials are usually used to make amorphous silicon cells.

 

Therefore, when we choose PV modules, we recommend you to choose the type of solar panels according to the actual situation.